These oxygen sensor fittings help you to complete your project with
quality bungs and great value. All of their standard bungs accept all
standard O2 sensors and are crafted from either T304 or mild steel. The
male end threads into your existing M19 x 1.5 O2 Bungs while the O2
sensor threads into the female end. Use one of the three included restrictor
to help trick the O2 sensor and eliminate check engine lights.
The kit comes with a bung that goes between the exhaust piping and your
sensor. The bung has a place for one of the three included restrictor
inserts to be
inserted and held in place with the supplied C clip. With three
insert sizes to
choose from, it should be enough to make even the most picky PCM give
you a CEL free dash again.
as a single piece. Order 2 for both sides if needed.