Product Reviews for 2015-21 Challenger HellCAT JLT Cold Air Intake
Here kitty kitty! JLT HELLCAT Cold Air Intake (2015-2020
Charger Hellcat 6.2L; 2015-2018 Challenger Hellcat 6.2L) 15-20
RWHP and No Tune Required!
Challenger Hellcat (Will not fit with Redeye hood or 2019+ Challenger
hood without modification)
has jumped into the Hellcat intake market with both feet. We have owned
a 2016 Hellcat Charger for nearly a year now and have been testing and
designing this kit the entire time.
kit includes a fully Roto Molded airbox that uses the factory fresh air
(Ram Air) inlet from the grille/headlight that also seals to the hood.
We feel this is the key component that puts our kit well above the
rest. Not only does this box help keep inlet air temps down by blocking
the filter from hot engine heat, it also helps hold in the cool air
getting rammed in from the inlet creating a high pressure area around
of the filter, our filter is a custom built design made by S&B.
It has a built in bell mouth for super smooth and fast air flow as well
as huge 1" deep pleats for more surface area than filters that look
intake tube is roto molded plastic with a huge 125mm for superior
airflow and NO heat soak like metal tubes. With
a mouth of 4.5" at the throttle body end, it is ready for any larger
throttle bodies that may come in the future.
and IAT adaptor plates 2015/16
Hellcats have a Mass Air Flow sensor and 2017-2020 have an Inlet Air
Temp sensor. We designed our kit to work with BOTH. Included in each
kit are CNC machined aluminum plates, gasket and stainless screws to
adapt to either model years.
new roto molded plastic heat shield to block engine heat at idle and
kit comes with custom designed and water jet cut Lexan shields that
bolt to the hood grille. Not only do they keep rain from the filter,
they allow the cooler rammed air to stay in the box around the filter
VS just being pushed out of the grille.
fresh air inlet from the grill.
a large area to make sure the filter has tons of cool air.
Plastic Intake Tube
S&B Powerstack Air Filter
molded Heat Shield
MAF adaptor plate
IAT adaptor plate
Charger Rain Shield
Challenger Rain Shield
Clamps, all needed hardware
Hellcat PCV Kit
AND TESTING 15-20
RWHP can be expected on a stock Hellcat 25-30+
can be expected on a pulley and tuned Hellcat See
all our testing videos below
design, detailed instructions and online video (see below) helps make
this an easy install (see Instructions & Videos tabs to
download / view).