SAME SUPERCHARGER AS THE
RECORD SETTING 2018 FORD COBRA JET!!
BETTER
IS NOT OPTIONAL, IT'S MANDATORY....
While
Whipple broke many rules and records with its record setting S550
supercharger system, holding the title of the most powerful, most
advanced supercharger system available, we weren't satisified and
decided to build an all new supercharger from the ground up. The patent
pending 50-State legal stage 1 supercharger system makes up to 750
(+355hp) engine horsepower and 620 (+220ft/lb) foot pound of torque on
93 octane fuel!
The
new supercharger system features the brand new Generation 5 3.0L front
feed twin-screw supercharger. Not to be confused with the Gen 3 or 4,
this all new supercharger features industry leading efficiency from
idle to redline. All new bearings, gears, rotors and housing allow the
new supercharger to spin faster, longer and safer while producing more
power than any other positive displacement supercharger ever built. The
new Gen 5 features an all new 3/4 rotor combination vs previous 3/5,
285 deg helix vs previous 270 deg, new bell mouth inlet, optimizied
dishcarge port and increased diameter vs length ratio for higher
efficiency.
The
Gen 5 also features an all new patent pending triple intercooler design
that has even more volume and surface area than the already massive
Whipple Cooler that cooled the Ford Cobra Jets and all the record
setting S550 Mustangs. Couple this with the industry's leading heat
exchanger, water reservoir and intercooler pump, you get more power
with lower boost levels and quicker recovery times after aggressive
operation.
With
years of OEM and racing experience, Whipple engineers have developed a
unique PCM calibration that reconfigures all the necessary engine
functions including fuel, spark, knock detection, torque management,
transmission control and electronic throttle control. The vehicles PCM
constantly monitors the engines torque output while monitoring many
different parameters to keep the engine in it’s ideal parameters. If a
parameter falls below specification, the PCM will lower boost and
torque output until the problem can be cured. No other calibration in
the field has such technology, giving the Whipple SC system unheralded
performance and reliability. Each Whipple kit comes with unique
software and a OBDII flash tool giving the customer the ability to
flash/update whenever needed. Each customer also gets the new Flight
Control Software, ability to adjust wheel/axle size, octane adjustment,
crank/cam relearn and many other unique features.
Each
complete Whipple system comes with the IAT2 harness and sensor to
properly monitor the delta between the incoming air and the compressed
air after the intercoolers, this helps maximize power in all given
enviornments. The 6-rib billet idler system features a billet spring
loaded tensioner, billet idler pulleys and lightweight pocketed
supercharger pulley. The 6-rib can easily be upgraded to a 10-rib with
the optional 10-rib system. Each system comes with an adjustable idler
pulley to allow variance in SC pulleys with minimal belt length
changes. The massive 150mm Roval inlet allows for nearly any throttle
body to be run, 80mm stock, 132mm or 150mm throttle bodies.
574-594-9559
